Browsed by
Tag: CentOS 6

Garrys Mod Linux server GLIBC_2.15 fix

Garrys Mod Linux server GLIBC_2.15 fix

Problem Facepunch Studio have released an update for Garrys Mod server that may cause the following error. Failed to open dedicated_srv.so (/lib/libm.so.6: version `GLIBC_2.15′ not found (required by bin/dedicated_srv.so)) or Failed to open dedicated_srv.so (/usr/lib/libstdc++.so.6: version `GLIBCXX_3.4.15′ not found (required by bin/dedicated_srv.so)) Facepunch have needed to update Garry’s Mod to use GLIBC_2.15.  because of this you will have the issue if GLIBC is older than GLIBC_2.15. This effects the following distros: CentOS 6 Debian 7 Ubuntu 12.10 or lower To…

Read More Read More

CentOS 6: Setting a Static IP address

CentOS 6: Setting a Static IP address

This is a quick tutorial on how to set a static IP address using the terminal within CentOS 6. Set the Static Address 1. Check which interface(s) you want to set as static. eth0 Link encap:Ethernet HWaddr 4C:72:B9:D1:D3:26 inet addr:192.168.1.58 Bcast:5.135.164.255 Mask:255.255.255.0 inet6 addr: fe80::4e72:b9ff:fed1:d326/64 Scope:Link inet6 addr: 2001:41d0:8:e77b::1/64 Scope:Global UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:640586231 errors:0 dropped:0 overruns:0 frame:0 TX packets:1476012131 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:98117934406 (91.3 GiB) TX bytes:953623859810 (888.1 GiB) Interrupt:20 Memory:fe500000-fe520000…

Read More Read More

Get SteamCMD Working with 64-bit Ubuntu (Without ia32-libs)

Get SteamCMD Working with 64-bit Ubuntu (Without ia32-libs)

Ubuntu/Debian ia32-libs has now been deprecated within Ubuntu and Debian. How becuase of this the following error will occur when trying to install ia32-libs. sudo apt-get install ia32-libs Reading package lists… Done Building dependency tree Reading state information… Done Some packages could not be installed. This may mean that you have requested an impossible situation or if you are using the unstable distribution that some required packages have not yet been created or been moved out of Incoming. The following information may…

Read More Read More

CentOS 6: Setup SSH to run on startup

CentOS 6: Setup SSH to run on startup

By default with CentOS 6 SSH is not configured to run on startup. Meaning you will have to activate the service every time before being able to use SSH on the CentOS server. To enable SSH to run on boot run the following command. chkconfig sshd on This can be applied to any service you want to run on boot. Once this is done restart the server and SSH will be started.